Jump to content
When you buy through links on our site, we may earn an affiliate commission.
  • Current Donation Goals

The Workshop Rebuild


fraggle42

Recommended Posts

Ok, ok, ok.

The Kitchen Worktop in the Garage rebuild :)

At the moment I've got about 15 foot of worktop to use, single depth (600mm), not great seating or lighting or mains power.

So it really doesn't get used much.

Right now it has this lot crowded onto it

Normal soldering station.

Surface mount solder rework station

Signal generators (2), scope, a few meters

Couple of PSUs

A few RF dummy loads

HF Kenwood ham radio & mic

VHF ham radio & mic

Desktop CNC mill & ancient PC with equally ancient CRT monitor

Tools here there and everywhere

Parts

Junk

Radio

And that's before I turn round and see the large rack of tools, boxes of older tools, old kitchen cupboards full of reels of cable, car and bike oils and stuff, garage heater, absolutely loads of dead UPSs & other stuff which are slowly being cannibalised for parts as needed.

Plus all the usual DIY car maintenance tools, jacks, axle stands, a new wing for a BMW E36.

Honestly every time I go in there I look around in despair, find what I need and leave in a hurry :)

NO MORE!

£200 of shelving, worktops and timber for the frames.

£100 of garage floor two pack paint.

And probably 3 months and 2 skips for all the crap will see it turned into a nice warm decent workshop with space, and everything I've kept nicely organised!

And I'll be able to unpack all those watch tools I bought and use them at last :)

So how many others have a garage you dare not spend too long in or you'll get lost in there? :)

Richard

  • Like 1
Link to comment
Share on other sites

This thread needs some pics    :please:     

 

 

Mine is about the same mate  :tongue:  I keep muttering to myself about the floor and cupboards (need painting) but I'll probably do what I always do and fix it up just before I come to sell the house   ;)     

Link to comment
Share on other sites

Richard,
I believe that everyone who works with tools gets into that dilemma at some point, especially if you have tools for car repair, bikes, carpentry electrical, etc.!! I had a 10X 14 workshop in my garage, under the main part of our house and it was terrible, as well as being dangerous. Old paint stored under the workbench, a radial arm saw with the dust it accumulated and tools, parts and junk everywhere. Two summers ago, I bit the bullet and built a 20X 30 foot steel building witha roll up 10 foot wide door at one end and a passage door at the other . a couple of windows, lots of big flourescent fixtures for plenty of light, lots of shelving and a full 20 foot length workbench on one end. It's now organized, I can find stuff and it's a pleasure to work out there.You will never regret organizing your workspace.

Link to comment
Share on other sites

This thread needs some pics    :please:     

 

You're going to regret asking for photos :)

 

Nightmares are made of stuff like this!

 

I've no idea where I'm going to put all the stuff in the first two pics

 

post-50255-0-52594700-1367169745_thumb.j

post-50255-0-88886100-1367169745_thumb.j

 

The existing bench is a teeny bit overcrowded

 

post-50255-0-33000100-1367169746_thumb.j

 

But I can sometimes get some work done

 

post-50255-0-73334900-1367169746_thumb.j

 

And get to play with this every now and then :)

 

post-50255-0-09335300-1367169747_thumb.j

 

Link to comment
Share on other sites

A little bit of progress.

 

Contents removed to the other half of the garage and the wall unit removed:-

 

post-50255-0-81932200-1367767287_thumb.j

 

And £300 worth of various bits of tree:-

 

post-50255-0-02539000-1367767334_thumb.j

 

And now I have to start assembling the jigsaw :)

 

  • Like 1
Link to comment
Share on other sites

I've been blessed with about 900sq feet of workshop in addition to a 2 car garage. Cars stay in their place, wife's junk stays in her place. <br />attachicon.gif

I hate you! :)

 

I'd love to have the space to build a workshop like that!

 

Link to comment
Share on other sites

Coming along nicely my friend.  What is your workshop's intention?  I spot some radio gear in your photos, are those related to what you plan on using this new found space for?

Link to comment
Share on other sites

Coming along nicely my friend.  What is your workshop's intention?  I spot some radio gear in your photos, are those related to what you plan on using this new found space for?

 

Well spotted :) Yes, there is radio gear there.

 

I passed my advanced radio amateur license a few years ago. I actually started learning it because I was bored and had a head start on the other students as I used to be an electronics engineer.

 

Now that I've got the license I don't actually use it that much - big aerials at home would cause too much friction between neighbours so it's 2M and 70cm bands at home, and I've got a multi band HF aerial that I got with the intention of using static mobile but haven't used it yet.

 

I've also got a Kenwood TS-450S and a TS-2000 in the living room.

 

This new space is going to be for electronic repair/alignment/calibration, learning to work on watches & clocks and I'll put the TS-2000 in there too, together with a spare laptop I've got for digital modes.

 

One big problem I've got is that those grey blocks that the wall is made out of are "aircrete"

http://www.aircrete.co.uk/

which must be the stupidest thing invented yet.

 

You can poke a hole in them using your finger! They have absolutely NO strength, the only benefit is light weight, thermal insulation and fire proof. All the things a normal breeze block is more or less, apart from the weight thing.

 

Which means that anything I build has to have it's own full supporting frame, or be suspended from the ceiling joists.

Link to comment
Share on other sites

The walls that use those aircrete blocks are the house walls, the garage is attached to the house.

It'd cost many thousands to replace them and then rebuild the kitchen and hallway :)

Richard

Link to comment
Share on other sites

It is a bank holiday in the UK today, and as is tradition for UK males, DIY was the order of the day:-

 

post-50255-0-48857000-1367865245_thumb.j

 

The upper and front lower worktops haven't been screwed down yet which is why there's small gaps under them.

 

I've got a Makita cordless drill and impact driver that take the same battery, and I've got one battery to share between them. I thought my work would be limited by how long the battery lasts and I'd have a few 30 minute breaks whilst it charged up.

 

It outlasted me. All day using the drill & driver a lot and the battery was still 2/3rds full, and I'm knackered! :D

 

The last few bits shouldn't take long to do, and then I've got to invite a few mates round to lift the thing into position. There's a gas pipe coming out of the floor (almost) right in the corner - there's just enough room to get this in, but the whole thing will need lifting over the pipe to get it into it's final position.

 

And then paint the wood white, install lights, install dado trunking and the mains sockets and light switches, wire everything up, paint the floor of both halves of the garage.

 

Link to comment
Share on other sites

Finished building the workbench and shelves now.

Now waiting on various EBay sellers to send me the trunking and other bits and bobs I need to install power and lights.


Richard

Link to comment
Share on other sites

  • 2 weeks later...

Floor painted with two pack acrylic garage floor paint.

 

Bare wood painted with one coat of white gloss, just about to do second coat.

 

And I've found a huge tin of brilliant white masonry paint and a few spare tins of brilliant white emulsion so I might as well use them too on the bare brick walls and ceiling :)

 

The garage will look like a strange operating theatre by the time I've painted everything.

 

post-50255-0-22430200-1368961725_thumb.j

Link to comment
Share on other sites

Great work mate, coming along nicely :)

Cheers!

After one (hurried) coat of white on the walls & ceiling its made a HUGE difference to the ambient light level. Used to be dark & dingy, not any more.

One problem with all this painting is the solvents & stuff really strip the oils & tears from my eyes, problems sleeping and sore eyes last night & this morning. I've got drops and artificial tears spray so will be fine today.

God knows how professional decorators do it!

Richard

Link to comment
Share on other sites

  • 3 weeks later...

Half way through moving all the stuff back in and sorting it out properly now.

I have one HUGE pile of rubbish to take to the tip :)

post-50255-137046840471.jpg

Richard

Link to comment
Share on other sites

Hahaha, the jack is only one behind the queen and two behind the king so can't be that bad :)

Sadly the poor cat didn't make it... Gone a bit mouldy now...

Posted Image

Richard

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...
Please Sign In or Sign Up