CptTripps Posted July 25, 2013 Report Share Posted July 25, 2013 I got a few generic inserts to play with. Lets see if I can do 40yrs of aging in under 2min.Step 1: Buy an insert.Step 2: Buy drain cleaner.Step 3: Find a plastic dish and add 1/4" of aforementioned cleaner.Step 4: Grab a kabob skewer or something WOODEN to pull the insert.Step 5: Be careful not to touch the insert with your fingers. Grease=bad. Plop the insert into the cleaner and watch it. At about 45sec, you'll see it start to change. At 60sec...PULL IT OUT WITH THE WOODEN STICK.Step 6: Run it under hot water for 30sec.Step 7: Run it under cold water for 60sec.Here's what you get!Viola! Link to comment Share on other sites More sharing options...
CptTripps Posted July 25, 2013 Author Report Share Posted July 25, 2013 Here's what it would look like on on gen 1675(Just placed it over the other one.) Link to comment Share on other sites More sharing options...
BigBuys Posted July 25, 2013 Report Share Posted July 25, 2013 (edited) Now drip some hydrochloric acid on it in ultra small drops and let them run. Flush with lots of water after varying the time of each drop. Baking soda is your friend. Second thought, submerce the bezel up to the color change line and dampen the intensity of the red. Edited July 25, 2013 by BigBuys Link to comment Share on other sites More sharing options...
CptTripps Posted July 25, 2013 Author Report Share Posted July 25, 2013 Now...do I have the stones to do it to my gen insert?...not yet.(But I sure won't be buying an "aged" insert any time soon.) Link to comment Share on other sites More sharing options...
CptTripps Posted July 25, 2013 Author Report Share Posted July 25, 2013 Second thought, submerse the bezel up to the color change line and dampen the intensity of the red. Thought about that. I may do it tomorrow. Just to see. I have another 1675 on the way, so I'm going to load this one up on that watch to see what it looks like. Should be cool. Link to comment Share on other sites More sharing options...
martijnp Posted July 25, 2013 Report Share Posted July 25, 2013 40 ages in two minutes and it looks good! Cool to see how you did that. Thanks for sharing Link to comment Share on other sites More sharing options...
CptTripps Posted July 25, 2013 Author Report Share Posted July 25, 2013 Unfortunately, I forgot that I'd already shaved the one insert to fit a rep case, so when I tried to put it on a gen bezel today, it was loose. Bummer.I'm going to do it to the other insert later today. Then, double-dip the red section to see if that has a better effect on it. I'm also going to wax the back, so it doesn't fade at the same rate. Genuinely faded inserts aren't faded on the back. ;-)This is going to look real cool on a Pan-Am dial that I have. Should make for a bad-ass watch! Link to comment Share on other sites More sharing options...
fraggle42 Posted July 25, 2013 Report Share Posted July 25, 2013 I'm going to get my rep Sub and throw it on the motorway at lunchtime.By the time I find it again at 3 in the morning it should have a lovely aged look Sent from my iPad using Tapatalk 2 Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now