Anyone have the dimensions of a Rolex 5512/13 PCG or a gen/phong case to measure?

[watchguy51]

I have an interesting project in the works right now, and I was wondering if anyone has the dimensions of a Rolex 5512/13 w/ pointed crown guards... or a gen/phong case to measure? I need every dimension of the mid-case and crown.

Also, the dimensions of a Helenarou 6538 bezel [notches] would be very useful.

 

Thanks everyone!

[dbane883]

41.6mm

[watchguy51]

Thanks you. The more details, the better. The length and width of the crown guards, the thickness of them on both ends... I'd like to be able to draw up a proper diagram

 

41.6mm

[dbane883]

CGs are 3.0mm. Lug to lug is 47.3mm

[dbane883]

CGs are 5.25 mm thick (dial to case back) at the base

[watchguy51]

Thanks so much for the info. Do you have the width of a lug at different points?

 

CGs are 5.25 mm thick (dial to case back) at the base

[watchguy51]

Also, are the pointed crown guards angled more from the top than at the bottom? Or are they symmetrical? And how far do they protrude?

[dbane883]

The tips of the peaks are collinear with the middle of the crown. Id say slightly north of center (toward the crystal side)

[watchguy51]

An [hopefully] the last question, what is the width of the lugs at their thinnest and thickest points?  Thanks again, this is all very useful!

[watchguy51]

bump 

An [hopefully] the last question, what is the width of the lugs at their thinnest and thickest points?  Thanks again, this is all very useful!

[watchguy51]

bump

[cc33]

The best approach may be to take very precise measurements from a gen 5512/3 and so the only approximating you would be doing is with the crown guards. There are hundreds of measurements needed for this and you shouldn't rely on others for the info if you want to do it right!

[watchguy51]

These are the measurements I'm looking for:

Width of the individual lugs at key points

Width of the crown and the gap between the crown and the case.

And the diameter of the crown is 7mm I believe?