3717 FLIEGER CHRONO

[travail manuel]

Could you tell me what is the outside index diameter
Is there someone who could make precise measurement

Thank in advance
Best regards

[markiemark]

Case is 41mm, without pushers.

[travail manuel]

Heeee,thanks, but I spoke about the dial - minutes index diameter and perhaps opening diameter

[markiemark]

Heeee,thanks, but I spoke about the dial - minutes index diameter and perhaps opening diameter

not sure what you mean...

[travail manuel]

Just what I say 

You have the crystal - after you have the stainless windows :opening ->DIAMETER?

after you have the black dial with white printing : minutes index->diameter?

I don t know how to say it by another way

[higginsd]

Oh. Someone has to disassemble his watch... I'm not sure you find someone without being lucky.

 

Question: what's your plan? Why do you need this measurements?

[Guest]

Perhaps you can show a picture of what you're trying to measure?

[travail manuel]

 

I have my own dial (look-like not gen ) so the diameter is 33mm  and looking for the case so I need to know if a rep case accept this visual 

that why I want this diameter (yellow  arrow)

Edited August 21, 2015 by travail manuel

[Guest REPPIN]

So you want someone to tear down a watch so you can replace a replica dial with another replica dial?

 

Good luck . 

[travail manuel]

I talk to somebody who will do a mod during next days or someone how have a gen dial in his desk drawer

After if someone could do the measurement through the crystal - with vernier caliper

Don't destroy you watch with hammer for me

[imajedi]

I have a rep dial I can measure.

[travail manuel]

Had you Sometime  to measure

It is nice of you

[imajedi]

Had you Sometime  to measure

It is nice of you

[travail manuel]

THANK YOU SO MUCH

could you make a second measurement : external 9-3 white index ..... to have the visual part diameter

 

[travail manuel]

After some calculations about proportions, I found 32.5mm  could you confirm?

after I will make some picture about my sterile project

I have the eta7750/sterile dial/hands but the case I have is not really suitable - I took a "parnis case" and I must do too much mod

that s why I'm looking for a rep case

 

 

Edited August 31, 2015 by travail manuel

[travail manuel]

this case is not as suitable as I would

[higginsd]

Cant see the problem exactly: dial too big or too small?

[Ephry73]

So you want to build a sterile 3717 with an Asian 7750 as opposed to the Parnis Quartz version?

[travail manuel]

not exactly , I repeat : I already have  eta7750/sterile dial/hands .but the case that I have is not really suitable: not very far, I think ....

but I have to adjust dial /crown tube thickness - removing -1mm of steel

 

if I can find a rep case ( close to gen's shape ) the 7750 will go directly in place regarding thickness

but I need to know if my sterile dial's diameter ( visual index) have the good diameter to the case's opening and vice versa

it was my first small request at the beginning -  I didn't imagine that it will occur so many questions

thanks you for your interest

 

ps : I think that the gen 3717 case is finest - rep case too I hope

Edited September 2, 2015 by travail manuel

[Ephry73]

The rep 3717 case is not bad at all, only issue is finding one.

[travail manuel]

Ok ,I had receive a faulty rep 3717 , all my spares are suitable

The gen/rep case is very beautyful - I did clean it ,little brush   I have the heavy stainless strap with