Help Needed-Phong case,Bracelet advice

[ronin007]

Hi,I've a phong 9401 case which I've put a yuki 5512 dial in ,all my rep bracelets fit it well,mostly with 580 end links ,my question is would this gen jubilee fit with these end links 555,

[freddy333]

I have never tried it, but the 555s are designed for a Datejust case, which has a different profile than a 55xx Sub case. So I do not think they would fit properly. Whether they would fit at all, I cannot say. Unless someone else has tried it, you would need to try it yourself.

[ronin007]

Thanks for reply,might just get it and see,from what i saw or have read,says there 20mm lug width,worst comes to worst I've some rep ones which fit so could swap them over

[SuperHero]

Your 5512 is gorgeous!

Sent from my iPad using Tapatalk

[ronin007]

Thanks it was  originally a snowflake and in some ways i should have left it,had a pvirus dial,hands with a wso insert but can be changed back 

Compared the 2,one on jubilee is mbw 1680 with gen insert and stern t-19,do prefer the yuki dial above the mbw,heres a pic of the phong case as a snowflake

[automatico]

You might use 550 jubilee hoods made for a GMT as the case is thicker than a DJ and the 550 hoods are made for 2mm springbars. Do not know if these hoods will work on earlier jubilees though as some I have seen had wider center links...C&I maybe?  You can spread the center links on later model swiss jubilees to accept the 2mm springbars. My 1675 is original and came with a jubilee when new with swiss made bracelet with solid end links and 550 hoods.

"do prefer the yuki dial above the mbw"

Me too. Also prefer the watch as a rolex. Fine looking watch btw.

[ronin007]

Thanks for the info and help,will order some and see,will update