HighDef Posted April 22, 2006 Report Posted April 22, 2006 Hi guys, I would like to replace the dial on this PAM. It has the Moljina inside. What black dial do you think will fit in here. I want to preserve that tiny second. I would appreciate any tip. Thanks.
Cucumber_Jones Posted April 22, 2006 Report Posted April 22, 2006 Talk to davidsen he can hook you up.
HighDef Posted April 22, 2006 Author Report Posted April 22, 2006 Talk to davidsen he can hook you up. Thanks CJ.
chris5264 Posted April 22, 2006 Report Posted April 22, 2006 Davidsen has very nice dials, I have two myself but there are some things to check first. His dials may be too large for your case, I had to trim my dial down about 1 mm. Not an impossible task, but if you take too much off you can't put it back. I would also check to see if the dial feet are in the same place.
HighDef Posted April 22, 2006 Author Report Posted April 22, 2006 Davidsen has very nice dials, I have two myself but there are some things to check first. His dials may be too large for your case, I had to trim my dial down about 1 mm. Not an impossible task, but if you take too much off you can't put it back. I would also check to see if the dial feet are in the same place. Oh boy,, what tool do you need to trim a dial? Is ti the thickness, or the circumference?
Bazz Posted April 22, 2006 Report Posted April 22, 2006 I have not done it on one of these but it would be the circumference, I did it on a rollie dial with a hand file taking it slow and checking progress regularly.
ubiquitous Posted April 22, 2006 Report Posted April 22, 2006 The Molj. movement is also a little funky to work with. It seems that when you pull the stem, the clutch will slip out of place. I am not sure if there is any way around it, but since you'll be replacing the dial anyways, you can re-set the clutch to it's proper position prior to putting everything back together. Best of luck... R
chris5264 Posted April 22, 2006 Report Posted April 22, 2006 Oh boy,, what tool do you need to trim a dial? Is ti the thickness, or the circumference? It is the circumference, I used my dremel and it took it right off. It is hard to mark the new dial and measure what needs to be taken off. I used the old dial and put it on top of the new one. lots of room for mistakes. If you look carefully at my dial at the right angle, you can see a place where the dial is too small. Can't really fix this but I am probably the only one that would notice it. Good luck.
HighDef Posted April 22, 2006 Author Report Posted April 22, 2006 (edited) With my luck, i will probably endup with a square dial with my Dremel. Thanks guys. I'll just buy another PAM Edited April 22, 2006 by HighDef
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now