Tom Posted July 5, 2007 Report Share Posted July 5, 2007 I am sending off my two PO dials to be re-lumed and have removed the dials from the case. The mechanism is still attached to the dial though. What is the best way to remove it? It is glued on in any way. Both mechanism are ETA if that makes any difference. Link to comment Share on other sites More sharing options...
FxrAndy Posted July 5, 2007 Report Share Posted July 5, 2007 They should be attached by pins solderd onto the back of the dial and held in the movement byby some hook looking bits on rotor side of the movement, just move the hook out of the way and the dial should come off. Link to comment Share on other sites More sharing options...
RWG Technical Posted July 5, 2007 Report Share Posted July 5, 2007 With the back of the movement facing you, place the stem in the up position, and look just to the right of the stem, you will see a half moon cutout and in this cutout the dial foot, and a small half moon lever holding it in place. You place a screwdriver flat against the small tab sticking out next to the dial foot and on the lever, twist the lever out and away from the side of the movement. The other dial foot is exactly 180 degrees from this one, one is at the 3:30 position on the dial, the other at the 9:30 position on the dial. RG Link to comment Share on other sites More sharing options...
FxrAndy Posted July 5, 2007 Report Share Posted July 5, 2007 You word that soooooooo well, what was the quote from blazing sadles, "You use your mouth prettier than a $20 hore" is there a gay thread round here somwhere? Link to comment Share on other sites More sharing options...
RWG Technical Posted July 5, 2007 Report Share Posted July 5, 2007 You word that soooooooo well, what was the quote from blazing sadles, "You use your mouth prettier than a $20 hore" is there a gay thread round here somwhere? Thank you...........I think........ RG Link to comment Share on other sites More sharing options...
babola Posted July 5, 2007 Report Share Posted July 5, 2007 I am sending off my two PO dials to be re-lumed and have removed the dials from the case. The mechanism is still attached to the dial though. What is the best way to remove it? It is glued on in any way. Both mechanism are ETA if that makes any difference. Just out of interest, are you planning to relume that 12 o'clock bezel dot marker as well to 'upgrade' its lume/appearance and make it more consistent with the dial ? I actually find it much easier sendin the whole watch head over for modding. In case you need a 'how-to' on PO bezel removal, see Pug's writeup somewhere on this forum - sorry I lost the link :-( cheers, babola Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now