Ylfig Posted January 4, 2008 Report Share Posted January 4, 2008 I have an old speedy from Precious time and my stem broke. This is the Seagull copy movm and domed crystal version. I haven Link to comment Share on other sites More sharing options...
POTR Posted January 4, 2008 Report Share Posted January 4, 2008 Where did the stem break off? If there is still stem outside of the body of the movement, then, you should be able to pull it almost normally with a pair of needle nose or good tweezers, albeit, after you uncase it.. If there is no stem visible outside the movement, then it MAY be small chance to get to the other end of the stem and push it out with a hand made bent wire tool without major disassembly, but I haven't seen this movement, so, I can't say for sure... Link to comment Share on other sites More sharing options...
FxrAndy Posted January 4, 2008 Report Share Posted January 4, 2008 You should be able to get a new stem from cousinsuk as they sell the movements or at least used to. Might be better to email them as i was looking for the movement online and it does not show under its old code of CH1901M Link to comment Share on other sites More sharing options...
Ylfig Posted January 4, 2008 Author Report Share Posted January 4, 2008 I already contacted Cousins in November. They didn Link to comment Share on other sites More sharing options...
RWG Technical Posted January 4, 2008 Report Share Posted January 4, 2008 The set lever stem release on this model is quite soft and with the movement out of the case you should be able to remove the stem, without having to take the movement apart. Even if you had to take the hands and dial off, once they are off, it's easy to get the keyless works taken apart, total time from start to finish is no more than 30 minutes. As for a stem, I need some of these as well, and I am going to measure one I have in the shop this weekend, and see if I can cross reference it to one in my Bestfit catalogue. If you don't hear back from me by monday, bump this to jog my memory. RG Link to comment Share on other sites More sharing options...
Ylfig Posted January 4, 2008 Author Report Share Posted January 4, 2008 Since I don Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now