How to assemble a PAM127

[jaykeem]

I was wondering if someone could explain to me how to assemble a PAM127.

I have all the DSN parts and was trying to test fit the dial but could not get it go in from the caseback. I also just tried putting an 01b dial and movement in and that does not fit either.

Did DSN send me the wrong case set?

[Dizzy]

dial goes in from the front

[jaykeem]

This is what I'm thinking will be required to assemble this watch.

Steps probably as follows:

1. Remove bezel and crystal

2. Mount movement

3. Install crown and stem

4. Mount dial

5. Set all three hands with a hand setter

6. Reinstall the bezel and crystal

7. Install the cg, caseback, and I'm done?

Think this sounds about right?

[PAMman]

I haven't ever pulled mine apart but I suspect that to assemble the 127 you should firstly assemble the dial and hands onto the movement (using a watchmaker's movement holder), then mount the unit into the case from the front, fit the stem and crown, fit the clamps, replace the caseback, then bezel and crystal.