bertieng Posted September 22, 2008 Report Share Posted September 22, 2008 Has anyone ever encountered the problem that the lever holding pin cannot be pushed out of the CG? Mine doesn't seem to come out at all even using a bracelet pin remover. Quote Link to comment Share on other sites More sharing options...
bwhitesox Posted September 22, 2008 Report Share Posted September 22, 2008 Yea I have...You just have to push harder and it will pop right out. Be careful though as it will shoot out and you could lose it real easy. Quote Link to comment Share on other sites More sharing options...
robertb Posted September 22, 2008 Report Share Posted September 22, 2008 I put the CG upside down on a roll of masking tape laying on it's side. When you tap the pin out, it gets stuck in the masking tape so you don't lose it. Quote Link to comment Share on other sites More sharing options...
capice Posted September 22, 2008 Report Share Posted September 22, 2008 priceless tip robertb..thanks for sharing Quote Link to comment Share on other sites More sharing options...
bertieng Posted September 22, 2008 Author Report Share Posted September 22, 2008 Tried. No matter how hard I pushed from the bottom, the pin just won't come out. Already made a deep dent on the pin end. Looks like I have to give up. Quote Link to comment Share on other sites More sharing options...
mikerblade Posted September 22, 2008 Report Share Posted September 22, 2008 Might be a bit late but I have had a CG pin that pushed from the top, looked like a normal CG just the pin holes were the same dia top & bottom Quote Link to comment Share on other sites More sharing options...
Ztech Posted September 22, 2008 Report Share Posted September 22, 2008 Might be a bit late but I have had a CG pin that pushed from the top, looked like a normal CG just the pin holes were the same dia top & bottom I was just about to say the same thing. Remember these rep manufacturers aren't making these off the original blue prints. Good luck. Quote Link to comment Share on other sites More sharing options...
sssurfer Posted September 22, 2008 Report Share Posted September 22, 2008 http://www.rwg.cc/members/index.php?act=fi...&pid=466566 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.