Wich 2 gaskets get replaced with one single gasket when fitting clark crystal?

[vizsladog]

Does someone have a diagram of wich 2 gaskets get replaced with the one single one???

Thanks for your help

[Star69]

Does someone have a diagram of wich 2 gaskets get replaced with the one single one???

Thanks for your help

here u go :

cheers,

Frank

[bertieng]

Have the same issue here.

Does it mean the Clark's sapphire with one piece gasket can fit straight onto the case - presumably the case shown above is an Euromariner.

Thanks.

[Star69]

Have the same issue here.

Does it mean the Clark's sapphire with one piece gasket can fit straight onto the case - presumably the case shown above is an Euromariner.

Thanks.

above is a Euromariner - yes - the Clark parts fit. you may have to work a little on it - see one of the topics.

cheers,

Frank

[vizsladog]

Thanks.....not sure what im looking at though. LOL.

[alligoat]

When I removed my Euromariner bezel this weekend, the crystal came off with it! I then pressed the crystal down and off of the bezel assembly. The bottom gasket was still attached to the crystal. I then dug the top gasket out of the bezel assembly- it's thinner than the bottom gasket. Frank's pics look exactly like what I encountered. I then put the Clark's crystal on the case, the gasket was already on the crystal. I was going to put it on with the crystal press, but in lining it up, it snapped right on with a little bit of thumb pressure! Then, after removing the top gasket from the bezel assembly- dug it out w/ a small screwdriver- I tried to get the bezel assembly apart, but never could. There's top and bottom inside rings, the click spring and the outer bezel ring. Rather than tear it up getting the parts apart, I simply pressed the whole assembly back on the watch case with the crystal press. I do think the inside top ring might sit a little too high for properly installing the bezel insert, but I haven't got that far.

Next, I have to enlarge the lugholes- typical MBW- they're to small, and trim the crown guards. Then I'll get squared away with my dial and hands and finally install the bezel insert.

[vizsladog]

Ah, i think i get it now....