vizsladog Posted October 26, 2008 Report Share Posted October 26, 2008 Does someone have a diagram of wich 2 gaskets get replaced with the one single one??? Thanks for your help Quote Link to comment Share on other sites More sharing options...
Star69 Posted October 27, 2008 Report Share Posted October 27, 2008 Does someone have a diagram of wich 2 gaskets get replaced with the one single one??? Thanks for your help here u go : cheers, Frank Quote Link to comment Share on other sites More sharing options...
bertieng Posted October 27, 2008 Report Share Posted October 27, 2008 Have the same issue here. Does it mean the Clark's sapphire with one piece gasket can fit straight onto the case - presumably the case shown above is an Euromariner. Thanks. Quote Link to comment Share on other sites More sharing options...
Star69 Posted October 27, 2008 Report Share Posted October 27, 2008 Have the same issue here. Does it mean the Clark's sapphire with one piece gasket can fit straight onto the case - presumably the case shown above is an Euromariner. Thanks. above is a Euromariner - yes - the Clark parts fit. you may have to work a little on it - see one of the topics. cheers, Frank Quote Link to comment Share on other sites More sharing options...
vizsladog Posted October 27, 2008 Author Report Share Posted October 27, 2008 Thanks.....not sure what im looking at though. LOL. Quote Link to comment Share on other sites More sharing options...
alligoat Posted October 27, 2008 Report Share Posted October 27, 2008 When I removed my Euromariner bezel this weekend, the crystal came off with it! I then pressed the crystal down and off of the bezel assembly. The bottom gasket was still attached to the crystal. I then dug the top gasket out of the bezel assembly- it's thinner than the bottom gasket. Frank's pics look exactly like what I encountered. I then put the Clark's crystal on the case, the gasket was already on the crystal. I was going to put it on with the crystal press, but in lining it up, it snapped right on with a little bit of thumb pressure! Then, after removing the top gasket from the bezel assembly- dug it out w/ a small screwdriver- I tried to get the bezel assembly apart, but never could. There's top and bottom inside rings, the click spring and the outer bezel ring. Rather than tear it up getting the parts apart, I simply pressed the whole assembly back on the watch case with the crystal press. I do think the inside top ring might sit a little too high for properly installing the bezel insert, but I haven't got that far. Next, I have to enlarge the lugholes- typical MBW- they're to small, and trim the crown guards. Then I'll get squared away with my dial and hands and finally install the bezel insert. Quote Link to comment Share on other sites More sharing options...
vizsladog Posted October 27, 2008 Author Report Share Posted October 27, 2008 Ah, i think i get it now.... Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.