Replacing the Crown Seal on my Sub

[HollyW00d]

Hello all, I was wondering if anyone can point me in the right direction here. The little black o-ring that seals the crown has broken off. I need to find a replacement, and was wondering if anyone here can help me. Thanks in advance!

[offshore]

Most of the wholesalers have crown seal kits, and they are not very dear.

Try

http://www.julesborel.com/

and look at P103 of their catalogue.

MQA-5 kit @ $5.95 for a kit of 50 mixed.

Offshore

[HollyW00d]

I messaged Andrew at TrustyTime and he is going to send me a new crown and pin, nice guy!

[HollyW00d]

Strike that, Andrew says he can't replace the part because the factory has closed down since I purchased it

I would just like to know if I could find a ring myself, I tried the link above but couldn't find it.

I couldn't find a page 108 with what you specified, I did find the gasket section in one of their catologues, but I'm not sure what the cross section size in millimeters is (thickness of the o-ring). I measured the inside of the crown where it belongs and it's about 3 mm, but I have no idea what the other measurement is.

Edited February 19, 2009 by HollyW00d

[Cats]

@Holly,

Offshore wrote page 103 so maybe it's on that page.

I didn't look so i could be the case that it's not there but just give it a try.

Carpe Diem

Cats