Cats Posted May 12, 2009 Report Share Posted May 12, 2009 I've been playing around with some end links that i've had laying around to mod them for gen springbars. I thought the easiest way to do it is by cutting the tubes ,that are in the endlink open, and bent them untill they accept the 2mm springbars. After doing this the springbar didn't stay in place so that wasn't the solution. Can anybody give me a hint or tip how to do this modd. Thanks in advance. Carpe Diem Cats Quote Link to comment Share on other sites More sharing options...
RWG Technical Posted May 12, 2009 Report Share Posted May 12, 2009 I cut them open with a Dremel cut off wheel, then I open them up and file as needed to get the spring bars to fit. Once the spring bar is installed, re-bend the cut portion of the tube to secure and hold down the spring bar in place. RG Quote Link to comment Share on other sites More sharing options...
Cats Posted May 12, 2009 Author Report Share Posted May 12, 2009 Thanks Zigmeister. I'll give it a try right now. Carpe Diem Cats Quote Link to comment Share on other sites More sharing options...
Nanuq Posted May 12, 2009 Report Share Posted May 12, 2009 Good advice. I've also found some old endlinks are worn very thin at the tubes, and there's just no structural integrity there. I've toyed with the idea of some silver solder across the gap once it's bent to the right diameter. Never tried it though......... Quote Link to comment Share on other sites More sharing options...
Cats Posted May 12, 2009 Author Report Share Posted May 12, 2009 Just finished them and it worked out well. I used a little sanding paper wheel to sand the bottum part of the old tube away to get the springbar as far as it could into the curved part of the end link. It's night time right now here in Holland and i always use sunlight to shoot my pictures so you have the wait at least untill tomorrow for the result. Thanks again Zigmeister Carpe Diem Cats Quote Link to comment Share on other sites More sharing options...
RWG Technical Posted May 12, 2009 Report Share Posted May 12, 2009 Great stuff, if you find that the tubes don't hold them in place, you can always epoxy the bar to the end link, it's not going anywhere anyway... Well done, RG Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.