i just got one of the newer T3 reps and like the watch but the slots in the bezel screws arent in the center of the screws on all of them
is there a fix for this, or a source for better screws?
these are the hexagon shaped ones you see in the top of the bezel
thanks
i like the size and design of the shaq but not a fan of the two red numbers (32), was wondering if it would be hard to change the red color to match the rest of the numbers during a re-lum.
also pondered doing a dlc coating on one at the same time
how do you think this would look?
thanks
just wanted to be sure since i have read above posts saying this watch is big, isnt it based on the standard roo case not the larger T3 case?
i dont think of the roo as huge any more
thanks for
have been away from AP for awhile and have not kept up with the case sizes, can someone please tell are the rubber clads, montoya, ruben and shaq all the same case size?
i have seen them listed as different depending where you look but think some of the difference is due to pusher styles
thanks
looks nice, wanted to ask is the size of this the same as the usual roo case?
i see some sites list it as larger but your photos make it look same
and is the sub dial spacing similar to the gen?
thanks
i was just there and didnt see the version you were refering to
do you mind possibly telling me where in the ap section it is
like how many down and over
thanks
i havent seen any rep T3 CG's with gen looking CG screws that have the (+) slots on the top, rather they usually have a (-) slot on the top instead. anyone know of a proper screw or how to mod the rep (-) screw to look gen?
thanks
great movement photos but they need to look like the RB with a central silver gear
i guess the RBii has a unique movement
i think francisco needs more to work with in terms of a photo
ken
i was thinking that punching a larger center hole in the center of very top plate and setting in a dummy gear in, along with proper engraving, and a screw head or two might be a good compromise solution with out messing with the movement
would this work? are there silver gears one could drill out to fit over center shaft?
thanks