dan_189

Looks gen, just from the back... could be wrong though Its fairly beat up

I have a genuine sub box if youre interested

Im in Melbourne

Yes it would fit the case, you would need a yuki 3135 or genuine 3135 or clip the feet off the dial to fit it to the movement you have

If you're after a Gen dial I have one let me know Cheers

Nothing should be vertical except for an engraved model/serial - M and V in a 16610. Some say late Z also had engravings but again vertical. One of the only downfalls of the TC and that it doesn't accept a Gen 93250. Get a Sean and polish it, becomes near Gen.

Haha I have a Gen bezel and insert just need a new retaining ring, willing to split?

So gen crystal heights vary? Or did I read that wrong?

Thats a pic before it's polished and before I put back in the tension ring. It works it's just a bit tight. Thanks!

Ive looked... nothing that shows a D serial specifically. It must vary through the years. There are pictures but none that show how high the crystal is because it looks different from each angle. The reason I ask is that the bezel on my all gen (with a Sean case) rotates without a tension ring inside it but it raises the crystal a fair bit. Not sure whats correct! Sitting flush and not rotating or sitting higher and rotating. I think the retaining ring is aftermarket. These are the only reference pics I have. Is the crystal on mine (bottom pic) too high??

Hey guys, How high does the crystal sit above the bezel on a D serial (2005/2006) Submariner? Anyone have any pics of a gen and how high or flush the crystal sits? Thanks!!

The Sean has the closest rehaut to genuine. Even the TC rehaut is wrong for a non-engraved rehaut sub. it is too vertical and not angled enough for anything other than a M or V serial. Cheers!

The top case the M95xx is a Sean/ETA Swiss case. The M58xx is not a Sean/ETA Swiss case. Can tell by the finish and the serial number. Cheers!

Out of curiosity, I too have a Sean case will all gen parts would you be parting out or selling whole?