Franken UPO tube came out

[edgematic1]

The tube of my franken UPO came loose and I was wondering what you guys use to put it in place. Some epoxy glue?

Thanks

[cib0rgman]

is this a rep tube or gen; for the gen one it will be better send it to The Zigmeister, he put a bushing in the case because the gen tube is smaller in diameter. He does a fantastic job. the rep one should not come off juts like that.

[edgematic1]

Gen

[Zackb911]

is this a rep tube or gen; for the gen one it will be better send it to The Zigmeister, he put a bushing in the case because the gen tube is smaller in diameter. He does a fantastic job. the rep one should not come off juts like that.

I thought the Gen tube was a direct replacement on UPO's, I never heard of bushing being required. Are you 100& sure on that? I'm ordering a Gen tube for my incoming UPO this week.

[cib0rgman]

not the older ones. I am not sure which version is this one. Maybe the newest 42mm PO is a direct swap.

[ianGP]

Hey edge, I used the same marine epoxy that I sealed the HE valve with to seal the gen tube in:

Here's my thread on it @ RWI:

http://www.replica-watch.info/vb/showthread.php/inside-franken-upo-build-60554.html?t=60554&highlight=ianGP

[edgematic1]

Thanks a lot Ian!