looseends Posted October 1, 2014 Report Share Posted October 1, 2014 Haven't posted in a minute, so I'd like to share today's tragedy. While giving a presentation, I noticed my Rollie has fogged over... on the inside! This is a few hours later with the crown open... I'm sure my wrist was hot and sweaty, but I've done this before without the same result. Not sure how moisture would have built up, and certainly the body heat was not an unusual level. Never gotten it wet and certainly never submerged it, as of course our reps are notoriously not water-proof. Must be a serious gap in the case I'm guessing, and that ol' moisture seeped in today! You could barely see the hands earlier. I will put it in a ziplock with a desiccant if I have any, or I guess rice supposedly works? This does not bode well for future performance. It has always lagged on a winder unlike a Deepsea right next to it. Maybe it's GMT shopping time again. Link to comment Share on other sites More sharing options...
dbane883 Posted October 1, 2014 Report Share Posted October 1, 2014 The caseback gaskets on reps can sometimes be improperly installed and as a result, will be pinched. This will compromise the integrity of the waterseal. If you open it up, you might find that to be the case. If not, either the tube/crown or crystal gasket are to blame. Either way, I would not panic. open it up and get a bowl of rice and/or silica gel packs and let it sit for a couple of days. 1 Link to comment Share on other sites More sharing options...
cib0rgman Posted October 1, 2014 Report Share Posted October 1, 2014 Dbanes883 I disagree with you assessment, this has happened to me specially when is very humid, coming out of A/C room and going out to a warmer place and humid. it will flog if the crown is unscrewed, just leave in the sun and it will dry out then close the crown and you should be good to go. 1 Link to comment Share on other sites More sharing options...
Zeal Posted October 1, 2014 Report Share Posted October 1, 2014 that sucks, probably crystal not correctly sealed 1 Link to comment Share on other sites More sharing options...
looseends Posted October 1, 2014 Author Report Share Posted October 1, 2014 I'm more on ciborg's side, if it were more serious as described by dbane I think I would have seen it sooner. It may actually be moisture that has always been in there and it just got hot enough inside but cool enough outside to condense. This is the first time and not under unusual circumstances. However, it is pretty clear now just sitting open crown in the shade on my desk. I will try to sun method first, and opt for "surgery" per dbane if it doesn't seem to be resolved. I just hate to crack 'em open, as even if I manage to get it apart and back together, I can scratch the hell out of 'em (I have the caseback opener, and tried the rubber ball, etc, I'm just no good with precise work!). Also for Zeal, the face and/or bezel were never properly aligned, so it is not a masterwork of replication let alone watchmaking to be sure. Could be the crystal. Link to comment Share on other sites More sharing options...
mrtoulouse Posted October 2, 2014 Report Share Posted October 2, 2014 (edited) Not sure from you pics, but some of the v2 Sub c's had problems with the cyclop glue that would start evaporating in hot conditions. Are you 100% certain it is INside the watch, or could this be another case of bad glue under the cyclop. Kind of random it should happen only in that exact spot Edited October 2, 2014 by mrtoulouse Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now