INCABLOC Help

[436NR]

Hi - I have a VS factory Panerai p.9000 series super clone movement that requires a new INCABLOC setting in the movement’s main plate. 

 

Impressed one out from a spare 7750 plate but it’s not compatible and wrong size. The p.9000 is the same diameter all the way through. The 7750 steps down in diameter towards the balance. 

 

Does anyone know what size this could be? I figure that the factory must be using one that they have in their other movement inventory.  The main plate is larger than a 7750 but smaller than a 6497. The 6497 INCABLOC is too large. I’d rather not buy a new movement since this is a fairly easy fix with the correct INCABLOC. 

 

 

p.9000 main plate with INCABLOC removed

 

 

Dial side of plate

 

 

p.9000 INCABLOC outer ring - the center was damaged while removing. I needed to replace the lyra spring that broke. 

 

 

This is a 7750 INCABLOC. I removed the spring to use in the repair. 

 

 

This is the 7750 plate. You can see that the INCABLOC hole diameter steps down. 

 

Any help would be greatly appreciated. Thanks. 

 

 

[Mike on a bike]

Hey hello buddy long time no see here hope all is well, sure somebody knows in the brain trust at RWG.

[436NR]

Hey hello buddy long time no see here hope all is well, sure somebody knows in the brain trust at RWG.

Hey pal! It’s good to be back posting. I never really left - just been lurking about.

I trust that you’re doing well?


Sent from my iPhone using Tapatalk

[Mike on a bike]

A lot going on but what else is new , good to see you posting.

[Sogeha]

Wow, good to see you back. Sorry I can’t help