Rolex Sub 19 Posted August 12, 2008 Report Share Posted August 12, 2008 I have a Noobmariner LV from TTK. I scratched the green bezel insert. Is it difficult to source a new bezel insert and replace it? I guess I only need to change the bezel insert instead of the whole bezel, right? Advises are appreciated! Link to comment Share on other sites More sharing options...
fotoman Posted August 12, 2008 Report Share Posted August 12, 2008 i'd recommend contacting Neil and seeing if he will send you a bezel - while your at it, see if you can get one for me, mine came smudged you can also buy inserts on ebay - but, there is no guarantee it will fit and may need to be filed. Personally, i have not had luck - in getting bezels from the same dealer that worked - silix sent me the wrong UPO bezel, then sent me new bezels - but, it wouldn't snap in - it was very close to fitting, but didn't fit like the orig my solution was to glue it - then cover it with rubberbands so the bezel held in place until the guerrilla glue set Had to chip off some excess glue with a razor - and unless you were looking at it from less than 2 inches away, you couldn't tell. if you put it right up to your eye you could notice that it wasn't set as flush as it should be Link to comment Share on other sites More sharing options...
alligoat Posted August 12, 2008 Report Share Posted August 12, 2008 Noob bezel insert is slightly smaller than a gen or the aftermarket ones- so you have to file it down- around and around you go, slowly and carefully. Or get a replacement from Neil (or maybe Chris @ Eurotimez). bklm1234 could make you one w/ a WM pearl, but it would cost you more, but it is an improvement. Link to comment Share on other sites More sharing options...
EuroTimez Posted August 12, 2008 Report Share Posted August 12, 2008 If it's hard to get it from Neil then you may contact me I can help you out, I have this parts in stock Link to comment Share on other sites More sharing options...
fotoman Posted August 12, 2008 Report Share Posted August 12, 2008 If it's hard to get it from Neil then you may contact me I can help you out, I have this parts in stock and tell neil i said hello. havent spoken to him in a long ass time. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now