Spare part question about ETA 2824-2

[Gorilladame]

Hi!

Fooling around with my yuki Today, I tried to fit a spacer in (again) but with fitted spacer the thingi in the middle which holds the hour hand is too Short :-(( and so I have to unmount the spacer.

Does anyone know which middle thingi ( hourwheel I guess) I need to have it long enough, and where to get it?

I guess at Ofrei, but I can not find anything in this shop, it is very confusing...

[omgiv]

If you replace the hour wheel, you may also run into problems wen fitting the minute and second hand. Jules Borel lists 6 different heights for the hour wheel (1.01, 1.26, 1.51, 1.76, 2.00, 2.26), 2 for the cannon pinion (1.95, 2.20), and 6 for the fourth wheel (4.15, 5.05, 5.30, 5.55, 5.80, 6.05). If you can measure the height of the hour wheel, we may be able to tell you what you need.

[stilty]

You'll need a set of H.4.

HW 1.76

CP 2.70

4w 5.57

I'm assuming the 2824-2 is going into a 1680 case?

[mjmj]

Are Yuki not selling the ETA adaptors with a Hand adaptor? When they first listed these adaptors they have the hand adaptors too. Does anyone know anything about these? Thanks

[Gorilladame]

You'll need a set of H.4.

HW 1.76

CP 2.70

4w 5.57

I'm assuming the 2824-2 is going into a 1680 case?

Right it is for the 1680, still not using your spacer because of that, it is a shame :-(

So do you Know where to get a H.4.?

Thanks to all!!

[Ephry73]

Bump for those looking for parts

 

E

[mymanmatt]

I don't know which hands you are using, sub, dj,etc. If you are using datejust I have long post hands that will solve your problem