Ronin Posted December 2, 2011 Report Posted December 2, 2011 Ok, what am I missing here. I have 4 different 25-325-10 casback seals which are supposed to fit 1655, 1665, 1678, 1680, etc... Why does it seem too large in diameter to fit in the groove in the case. (GEN 1675). Thoughts?
Ronin Posted December 3, 2011 Author Report Posted December 3, 2011 I have a feeling the 3 pack I ordered from Ofrei is simply wrong / mis-labeled. The OD is nearly 35mm. Went ahead and ordered from another source.
automatico Posted December 3, 2011 Report Posted December 3, 2011 (edited) "I have a feeling the 3 pack I ordered from Ofrei is simply wrong / mis-labeled. The OD is nearly 35mm. Went ahead and ordered from another source." Probably the wrong gaskets. 29 = part category 325 = 32.5mm 10 = 1.0mm I had to stretch a few out a little before installing them...aft/mkt, not genuine. Maybe you got 'regular' and you need 'bull size'. Ha! I'm talkin' 'bout caseback gaskets here. Oh no... I read it bassackwards. I'll shut up. Edited December 3, 2011 by automatico 1
preacher62 Posted December 3, 2011 Report Posted December 3, 2011 I've had some that seem a little large (even if I just took it out of the watch), but when I put silicone sealer on them and make them sticky, I can install them fine. It causes them to bulk up just a hair and seal good.
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now