Jump to content
When you buy through links on our site, we may earn an affiliate commission.
  • Current Donation Goals

Watch cleaning help


Ezio

Recommended Posts

Hey guys since its Nice weather my watch have been getting dirty alot

What should i do to clean it take the band of and put in a Bowl with soap ;) haha

Thanks in advance

Link to comment
Share on other sites

Question: doesn´t the ultrasonic clean the "inside" of the watch (movement) as well leaving all dirt floating around?

Or vibrate some tiny screws off?

 

Have only used an old toothbrush and non-abrasive tooth-paste, treated bracelet in separate with the usual rec´s.

 

PS: I´d like to buy one but just for cleaning bracelets and other stuff don´t know if I should...

Edited by Nightwatch
Link to comment
Share on other sites

Question: doesn´t the ultrasonic clean the "inside" of the watch (movement) as well leaving all dirt floating around?

Or vibrate some tiny screws off?

 

Nope: it runs at 42kHz, DEFINITIVELY to much to make whatever part of metal to vibrate.

Moreover it doesn't work "shaking" the parts: only the parts in contact with the water will be affected: the process use the so called "cavitation".

 

From Wiki ( http://en.wikipedia.org/wiki/Ultrasonic_cleaning ):

In an ultrasonic cleaner, the object to be cleaned is placed in a chamber containing a suitable solution (in an aqueous or organic solution, depending on the application). In aqueous cleaners, the chemical added is a surfactant (eg- laundry detergent) which breaks down the surface tension of the water base. An ultrasound generating transducer built into the chamber, or lowered into the fluid, produces ultrasonic waves in the fluid by changing size in concert with an electrical signal oscillating at ultrasonic frequency. This creates compression waves in the liquid of the tank which ‘tear’ the liquid apart, leaving behind many millions of microscopic ‘voids’ or ‘partial vacuum bubbles’ (cavitation). These bubbles collapse with enormous energy; temperatures and pressures on the order of 5,000 K and 20,000 lbs per square inch are achieved; however, they are so small that they do no more than clean and remove surface dirt and contaminants. The higher the frequency, the smaller the nodes between the cavitation points, which allows for cleaning of more intricate detail.

 

I'd only be careful in presence of not rust-proof parts (i.e. the bracelet pins if not stainless): in this case I'd use ethanol or methanol instead of water as cleaning liquid.

Link to comment
Share on other sites

I use the ultrasonic only to clean disassembled movement parts during service. Case and bracelet gets warm water, mild soap, and soft toothbrush.

Link to comment
Share on other sites

Yep, foaming hand soup and soft brush and warm water works great. As stated in other threads doing a treatment with the Teflon dry chain lube like "white lightening" also keeps it from collecting dirt.

Sent from my droptop using telepathy.

Link to comment
Share on other sites

Cavitation bubbles like to start at imperfections / minute cracks / valleys in the material, and as such an ideal place for them to form is where the rubber seal contacts the case, which is where you really don't want minute bubbles to form, when they form they'll push the rubber away from the metal case, and when they collapse they'll create a shock wave pushing the surrounding water away, further under the rubber seal.

 

I doubt a low powered US cleaner hs the power to overcome the rubber seal unless it was damaged or the back / crowns weren't tight though.

 

Another place would be the seal around the crystal, and imperfections in any paint on the bezel.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...
Please Sign In or Sign Up