GenTLe Posted November 21, 2015 Report Share Posted November 21, 2015 I wanted to put this in the how-to section but looks like I can't post there (at least from tapatalk).So I received a nice shiny115400 TFactory and, as I do for all my newcomers, I proceeded to regulate it and grease all the gaskets.Well, be careful with them because the part with the movement is just "sandwiched" between the case back and the bezel with front crystal.What I mean is that when you unscrew the caseback (supposedly having the watch laying flat face down) the whole case is disassembled!If you lift the watch at that point, the bezel and the 8 screws will remain on the working surface and the movement and its ring will stay more or less in place just because of the stem...My suggestion is to wrap together bezel and case BEFORE unscrew the case back:That way the movement middle case and bezel will stay in place BUT you can't then grease the bezel gaskets.If you want to grease the 2 bezel gaskets too (like I did), then it is a bit more complicated: you should not put the tape, but remove the case back while the watch is laying on a surface that you can lift. After you removed the case back then lift the whole working surface together with the watch head and, keeping an hand on the watch so that it stays in contact with the working surface, rotate everything to have then this situation (note that in the pic the case back and bracelet are attached just because this is an example pic, in the reality you shouldn't have both):Then you can remove the working surface (piece of flat wood in upper pic), put the watch on the table and lift the bezel to grease the gaskets.Do everything in the reverse order to have it back face down and being able to close it again.Cheers, GenTLe.Ah, the regulated and checked finished one: Link to comment Share on other sites More sharing options...
mule play Posted November 21, 2015 Report Share Posted November 21, 2015 Nice. What do you charge for this service? Link to comment Share on other sites More sharing options...
GenTLe Posted November 21, 2015 Author Report Share Posted November 21, 2015 Nice. What do you charge for this service?For the post? I accept donations Jokes apart, I only work on my pieces (and believe me I have enough to spend half weekend un them ) 1 Link to comment Share on other sites More sharing options...
kernow Posted November 21, 2015 Report Share Posted November 21, 2015 Simple but sound advice. It's such an easy mistake to make and then you're scrabbling round on the floor looking for small screws etc. Well said GenTLe Link to comment Share on other sites More sharing options...
SSTEEL Posted November 21, 2015 Report Share Posted November 21, 2015 (edited) They are an interesting construction thats for sure, I was surprised the first time I had one in for refurbishment, and refinishing. The movement is secured to a inner thick, weighted ring/spacer. The mid-case tube secured to it, you can get the central weight out without removing the crown tube, but I prefer to simply remove the tube anyways seeing as I need it out the way for re-brushing the case.Some of these new AP's sec@12 models are interesting too with the way they are constructed, similar to a jigsaw puzzle lol Edited November 21, 2015 by SSTEEL Link to comment Share on other sites More sharing options...
pick_br Posted November 23, 2015 Report Share Posted November 23, 2015 Thanks for the tip ;) Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now