PO Ceramic QC picture? Is the pearl looks ok (center)?

[dvn]

[rocky4691]

It looks off by about 1 click to me.

[CokeSmurf]

Way off, like pretty much all the other reps.

[SSTEEL]

The photo angle is not helping either.

[Mike on a bike]

Need to see straight on with 30 at bottom to see how it lines up. The 45 at 9 is not helping per steel because of angle.

 

[dvn]

How about this one?

 

[ZedWings]

I've noticed something with a lot of reps, that either the pearl is oversized or the triangle is undersized. On the gen, and some reps I've seen, there is a larger gap between the edge of the pearl and the edge of the triangle. I noticed this on my QC pics, and mentioned it to Andrew, but he told me that's just how it was, and that I could either accept it or cancel my order. Strange that I saw a rep on this site that was also from TT, and had a very good pearl with acceptable gaps.

[cougar1]

It seems all the 42mm black bezel CPO reps and the LM 45mm reps have pearl a little lowish, some better than others. The 45mm are better and the pumpkin also. You might get a little better if you reject and reject but unlikely. I seriously hope noobs upcoming releases of these Ceramic POs deal with the location of the pearl once and for all.

[indywatchguy]

Its a scam by the Chinese to keep us rep ocd geeks hooked on the dream of a perfect rep. Which will never exist not because they can't but won't.

[tyrantblade]

looks horribly low, and i thought the pearl on my incoming Ceramic PO was bad enough (its higher up than that at least). 

[fraggle42]

Looks fine to me.

I mean, unless you carry round a loupe and use it to read the time from your watch every single time, you're never, ever going to notice its off by 0.2mm.

And remember that when you get it and check it very carefully, you'll see it then, but after half an hour wearing a new watch I completely forget minor thing like that as I'm enjoying just looking at the watch as a whole, a very pretty, very nice, new and shiny thing!

Richard

[scotty]

Some dealers getting annoyed when you reject qc pics for the pearl position. When i bought my Ti there a moment of conflict and i was told the order would be cancelled!

[agantz]

I've seen a gen with a pearl that wasn't centred perfectly. That's more than acceptable in my opinion for a rep