Hi!
We all know that changing the tube and crown is a must to do.
I have a couple of questions wich i´d like to know, so thanks in advance and hope this post helps another member.
In a post of this repair section a member asked if he would replace the crown, Tribal comes in and says this:
After reading this, I wonder that a drilling machine should be used. Then what is the good size to start with?
Can we start directly with a drill of 2.8mm?
After drilling the tubehole, Do I have to use a Rolex tap for 6.0MM Tubes like the pictured below?
How do I use it?
After retapping, then comes the new tube placement, How does this thing works?
What if I have an old style case with a 5.3 mm tube installed and I am planning to put a 6mm tube?
Is the hole of this case too little to perform these operations or its just fine?
Thanks a lot and Regards,
Manuel