Need some insight

[marrickvilleboy]

Got this in the mail - a 5512/5513 that has a broken tube.

Whats the best way to get this out?

thanks!

[freddy333]

Simple, but you will need a small round or triangular hobby file

Insert & wedge the file inside the tube & unscrew. I would replace with a new Swiss-made aftermarket or gen tube (you can buy gens on ebay or tz, or Swiss-made aftermarkets from Ofrei, Cousinsuk & most watch parts houses).

[cjjoyce1]

If you don't have a file small enough. I've also used a small hole punch and a nail set in the same manner.

[JoeyB]

The file should work, or you can use an 'Easy-Out' screw extractor. Kit is under $10usd at most any hardware store. The bits are reverse thread spiral, 'bites' in the hole and you then just reverse twist it out.

[highoeyazmuhudee]

careful using a file i always seem to break off the tips in the hole.

+1 for the screw extractor

[alligoat]

I broke the file removing a tube from my PT 1665

Next time I'm using Joey's suggestion and buying some EZ-out screw extractors

[freddy333]

I have been using the same file for years (without any problems), but, just to be safe, a screw extractor is probably a good investment.

[jmb]

You also might want to remove the bezel and crystal and apply a little heat to the area to loosen/soften whatever thread-locker or sealer might have been used...