Cats Posted March 15, 2012 Report Share Posted March 15, 2012 I just got my gen top hat crystal form Justasgood in today. It was used and i knew that i had soem signs of wearing. I has a few scratches on the top of the crystal. I want to use Polywatch to remove the scratches. I some tutorials i see that i have to use a very fien waterproof grinding paper first and afterwards you apply the polywatch in order to get the mirror shining surface again. Can anyone give me an advice how to get the scratches out. Thanks in advance. Cats p.s I'll shoot some pictures tomorrow to show the scratches Quote Link to comment Share on other sites More sharing options...
dbutlerman Posted March 15, 2012 Report Share Posted March 15, 2012 You may not need to fine Sand Paper - depends on the scratches - Polywatch can get rid of some pretty decent scratches all by itself. What I do is as follows: Put about a Pea sized dot of polywatch on the top of the crystal and then rub it in a circular motion until the polywatch disappears and the crystal is clear - repeat as necessary. Depending on the depth of the scratch it may take several attempts... I've gone the wet sand paper route - but they were really deep scratches... Quote Link to comment Share on other sites More sharing options...
permabull Posted March 15, 2012 Report Share Posted March 15, 2012 I just used some yesterday on a vintage plexi. Have been using it for years, never tried it with sandpaper, never had to. Depends how deep the scratches are i suppose. As db2 said "Put about a Pea sized dot of polywatch on the top of the crystal and then rub it in a circular motion until the polywatch disappears and the crystal is clear ..." Rub with some pressure for about 3 minutes. Quote Link to comment Share on other sites More sharing options...
Cats Posted March 15, 2012 Author Report Share Posted March 15, 2012 I assume i can rub it with a cotton cloth or with a swab. Carpe Diem Cats Quote Link to comment Share on other sites More sharing options...
FxrAndy Posted March 15, 2012 Report Share Posted March 15, 2012 I use my finger bert, just to rub it in and then polish off with a soft cloth, even if it has deep scratches it will give a nice sheen. Quote Link to comment Share on other sites More sharing options...
Cats Posted March 15, 2012 Author Report Share Posted March 15, 2012 Thanks Andy i will try to do it myself and if it doesn't come out the right way i can always ask a member to help me out Carpe Diem Cats . Quote Link to comment Share on other sites More sharing options...
mikellem Posted March 16, 2012 Report Share Posted March 16, 2012 Bert, Follow Andy's way, and you should be fine. MM Quote Link to comment Share on other sites More sharing options...
hackR Posted March 16, 2012 Report Share Posted March 16, 2012 i use cape cod cloth...works great... Quote Link to comment Share on other sites More sharing options...
Jkay Posted March 16, 2012 Report Share Posted March 16, 2012 I discovered Cape Cod for polishing plexi several months ago. Works fine for me. Quote Link to comment Share on other sites More sharing options...
SSTEEL Posted March 8, 2014 Report Share Posted March 8, 2014 Here's my results, before and after using polywatch on a Swatch `windfall plastic crystal.. Before: The light scratches on the plastic crystal result is a fog look, and stops the dial from showing its full detail. Couple of small blobs of Polywatch onto the plastic crystal, working it over the entire surface, then using cotton wool, work alloying pressure in a circular motion, then up down, left and right for a few minutes. Here's the result... The dial POPS now Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.