Rovin

Can anyone assist with how to source the case/movement? I can build it, just unsure as to best source of parts.

What's the best case to put these into?

It is not a great job, grainy lume and not centered on the painted marker. I've been on the fence about doing it for a while, and am now set on this. And yes, it bugs me plenty!

Having a real pain of a time trying to source engraved rehaut model crystals and gaskets. I have a gen 36mm in bits, and Rolex will only supply if I send them the whole watch. But it has an engraved case ack and they will insist on replacing it. So it ain't going there. Also have a rep 42mm explorer, and need a crystal and gasket for that too. Does anyone have a contact that can help out?

Awesome, kudos to you!

I wonder if a Phong Rolex dial will fit with an ETA low beat into this case? I have these already, in a bad cartel case.

Thanks mate. Have had Domi do some other work in the past, had to ship from Australia to UK and than across, but worked out.

Now that I have stuffed reversing wheels in my 237 and have to pull it apart, I figured I've had enough of the grainy and misaligned lume on my 237 and want to get it done properly as I do like this watch. Any opinions on who can scrape off the old and re-lume perfectly?

Looks great! Would try to get taller CP tho.

Hi folks, Been told you can't get them. Anyone know if this is really the case?

Woo hoo! Just ordered two of these, looking forward to fitting them up!

Here's a great solution to a problem. If you're going to make them again, I'm down for three.

Was anyone going to get into making these? I'd have to go and buy a new printer anyway, and would rather pony up for a good version than a new printer..... Just sayin'.....

Sorry, been away! Yes, did a full gen parts bin build up. Was about a year ago, and whole thing cost $1,700, with movt service and replacement crown and tube. The Cousins supplied case CT had the crown sticking out too far and I stripped the thread on it when trying to get it closer to the case....

Here's a profile shot of the gen case I used to build mine: