Leaderboard

Weekend production

6610 test in jmb V2

6610 Explorer dial today And a 6538 for a friend Bubbles will disappear after few hours. 10x

Sale Man! CARZY!

As stated in the pinned 'Ultimate Rolex Mercedes Hands Comparison' thread: I believe that the chapter ring itself measures 26mm in diameter on chapter ring dials. For our purposes, Gen or aftermarket outside diameter of the dial itself doesn't matter to hand size. Only the chapter ring size does. On the early GMT and Submariners, a 13mm minute hand was used. That put the tip of the minute hand right to the chapter ring. The small arrow GMT hand used on 6542 and 1675 chapter ring dials also measured 13mm, and the tip met the chapter ring. =========== For accuracy, what matters on a dial is the hand length to the markers, not the outside of the dial you are using to fit a case. The later GMT and Submariners up to the maxi hands used a 12mm minute hand. That is short of the chapter ring.

Just finished a golf tournament. Wearing this today.

Thanks ! I retouched dials again to reach better details. There is a gap because I don't print decals at the dials size for the 6538 and 6610. If I print at 29mm, the train is too close from the rehaut and "SWISS" is hidden. At 28.5mm print size, the edge I hidden by the rehaut and SWISS is clearly visible. And the minutes hands are closer from the markers.

Brilliant work Bart! You're creating some amazing builds

5513 dried

It was a long time waiting to get this one back but here she is again. Service + Profsteve AR

The MBW will accept genuine parts, so the insert should work OK as well as the T-39. Here is my MBW based 1665. Gen insert, Crystal, crown, hands, movement, bracelet and endlinks. Sent from my iPad using Tapatalk