kent2

the plate is from the net from a badge seller in italy. about 15 euros i recall. and the pig is an italian model kit i built for another 15 euros

the poem is by a cryptographer leo marks. his book is a brilliant read. http://en.wikipedia.org/wiki/Leo_Marks

finally after about 3 years of fussing about i have my desk set done. only to discover i want a third variant too.

could we see a picture of your rig ?

does the second hand still sweep but the hour and minute hand stop ? but when you wind the hands in the setting position the hands move ? could this be a loose cannon pinion not picking up the power from the centre wheel ?

acklands. the number drill bits ie #54 etc. drill undersize and hand ream for drive in fit

will send you a pm

the 5.3 tube should fit however all reps have qc problems and you may need to re-tap the hole. there is never a guarantee that gen parts match the reps in regards to thread dia and pitch

just wondered if anyone has built yuki's 5517 mil sub. looking for a project...not a pain though using a gen 1530 movement

i have had the same issue twice from ndt. very aggravating. it was not the movement. i made a scraper out of a triangluar file and cut the ring down to allow the movement to drop in. the second time i chucked up a round diamond stone in a jewellers drill press and carefully with small cuts got the ring cut down and then scraped it. the scraper is just very hard steel and hollow ground on a wheel minding heat build up not to loose the temper

three rubies and one date seating rivet

I happen to have a nos correct date seat...for the gmt

does anyone know of what the market is asking for a gen 618 rollie movement ? tia

the second hand is carried on the fourth wheel pinion. the tube on second hand that slips over the pinion is double in length of a regular movement ie a 1530 vs a 1565gmt. i just wonder if the ofrei part would work. if it did i would like to do that mod too

would not it need a long post as it is a gmt hand ?

perhaps in brass/bronze ?

its a personal call but...to pay that much... i think you would be better saving up til you can get a genuine tudor sub. you would not loose money on a genuine. it is perhaps better to use replicas for watches that are just plain stupid to buy ie a mil sub or daytona(in my opinion)unless money is of no concern of course

go with the white hand. it is more visible and in my opinion suits the deep black dial better. i just have one with a white seconds hand but will do a conversion when i can find the drive

nice panda. are you a watchmaker ?

are you looking for a specific movement ? rolex has technical information booklets based on the calibre ie 1030 or 1530

i have found a donor. only thing is i am really starting to like it to much to strip out the movement. i wonder if there might be a better route val 72...

is the dial needed 26mm in diameter? i have this and was going to do something. it has languished in my parts box. it is a genuine dial

oops

just curious did the cadbury secret surface ?