FxrAndy

It can be a pain the first few times mate, i still stuggle some days, other days they drop right togehter and you find it hard to belive they did, perseverance and experience mate thats all

Does this crown pos look correct?

Correct on both counts, if you wind the crown the pin will move out of the teath you can then hold it back with a sharp bit of peg wood while the power runs off

have a look mate

I think Prist wants top remove the click from the aquatimer so that it would be bidirectional

Navitimer Planet ocean heuer god there are thousands

I think i would just leave the tudor as it is mate

Welcome to RWG, always a warm welcome here.

I have merged both threads that you started together, I was just looking for a phantom my self last night and could not find one either.

I would say that is a very old 2836

Cats let me know if you want it drilling, i will do it mate.

Not seen the inside of one but i am sure it is just the case of removing a click spring

A schuhren today

$200 was a steal for that!!

Rupert do you realise that the and stack from the 2836 id different form the rolex movement 2836 GMT hour min second rolex hour gmt min second so gen hands will not work, the best solution may be to get the standard hands, and arrange a trip to ziggy for them, i belive that he can now get PVD/DLC coating done and then he could lume them as well, proberbly not cheep but you will have the best fitting hand set

Hmm ok

When i needed a new one a while ago i got it from one of the cartel sellers, josh or andrew i think, give them a mail and see if they can get you one. When i needed a new one a while ago i got it from one of the cartel sellers, josh or andrew i think, give them a mail and see if they can get you one.

I think your best bet would be to ask conceptor if he can get Gen hands for you

Thanks for vote of confidence from the Admin team in me to fullfill this position, and i hope i can serve the membersip for RWG in the way i have been served in the past. now when do i get the Latitude and longitude to the staff island (and where has the post gone about it)

Still the Ingy, but i may wear a blackbird this evening to keep in theme

done

Now they wont, the best you can get to fit will be tudor

These compressor cases are not such a bolt in project as many may think, you have to have the date wheel that they sell as a standard will not work if the crown was offset from 3 by 11.61 degfrees or multiples of that then it would work, this crown is off set by roughtly 17.41 degrees so a date wheel (i could buy a white one but i did not want white i wanted black) had to be made up to suit by sanding 2 date wheels down and adding them together. Also the movement holder has to be modded to fit, it is supposed to be for a 2824, but needed to be made a little larger, also i am using a 2892-2 so a movement space has to be used and i have to change the hour wheel, canon pin and seconds wheel to clear the dial with the hands Other options i wanted to do but are looking to be too much work right now are to fit screwdown crowns, but then the case will have to be drilled to take the tubes Re print the inner bezel to GMT and fit a 2893-2, again a lot of work and not a lot of time right now

Thanks for the replys guys, it is for a personal project based on the compressor internal bezel case so gen but non branded, Late last night i found that sin uses the one that i may need but by then i had made one any way,

Still and Ingy day Hi Pugwash where you been?