cib0rgman

Check First post

The TW Bezel must be thinnner than TCs, because i have a crystal from tc which he told me that is a 1.8 which is Gen spec and the 2.7mm gasket but the crystal sits too low and the date mag seems to be off a little

I am going to post a picture tonight of how i made my own crystal press. Like I say before I used and sprinkler head that i cut, I am going to install the 2.7mm gasket and see how it looks.

here is a side by side, I still think that the 2.7 Gasket will do the trick. the crystal is a little tad to tall.

is pretty easy, I made a crystal press by cutting a sprinkler head it has the right size, a couple of pieces of wood and a hand press

I have a 2.7mm gasket that I need to try, but i do not know how to remove the gasket from the crystal without breaking it

The pearl is fine is just the pictures

There is so much radiation everywhere that I do not understand why would anyone worry about that....

you can also get a Windows 7 phone. you may actually like what you see

I installed a Clark's crystal yesterday and i used the 3.0mm gasket I think it lookd better than TC's Crystal, does it looks too tall on the profile Here is the TC with the Clark's Crystal and the 2.7mm gasket which I think is spot on. i like it a lot. Home made Crystal Press, I use the one to press down the ring and the smaller one to push the crystal out of the ring, make sure that protect the case and crystal in the process.

How do this one compare to Sean or TC cases these ones also take Genuine part can can house a Gen movement.

who is start time?

do you have a picture of the broken insert. can you share it?

I was thinking the same but it has no bracelet another $600-800, may as well buy a Gen

That will be the 2.7mm Gasket?

nothing yet, the asking price is $1,600 is a X serial not sure which year will it put it

Does BK sell juts the DWO overlay; about Bezel do you mean is too tall in other words too thick....

What do you guys think about this case

Sean is too pricey Sent from my SGH-i917 using Board Express

Just be prepared to wait, be patience and you will succeed.

What would you change on a tc, the dial, insert and crystal and you are done, the crown also but is not a must Sent from my SGH-i917 using Board Express

ditto TC told me that is 2.7mm maybe it need 2.8 Clarks ebay maybe

start from one end pushing your way in until it can go any further down , then you need to use something harder your finger will not do, use a plastic tab or something that will not scratch the insert and push down it will snap trust me i have done several times and now i am an expert.

Where you got that one?

Yes it id a gen insert Sent from my SGH-i917 using Board Express