436NR

FYI Guys… the newest TC case isn't compatible with a Gen 3135. He made some mods to the case and one of the cutouts to drop the movement into the case is in the wrong place. One of the movement securing screws sits right on the edge of the slot. It won't allow the movement to be secured. I'm working on a mod to try and remedy it. Sent from my iPhone using Tapatalk

Me too! Sent from my iPad using Tapatalk

I'm in! Sent from my iPhone using Tapatalk

Sent from my iPhone using Tapatalk

Sent from my iPhone using Tapatalk

VERY NICE!!! Welcome to the DSSD Super Franken Club! You're the king of parts connections, my friend. I'm so happy that you finally finished her. Wear her in great health Sach! Mine says hola! Sent from my iPhone using Tapatalk

Sent from my iPhone using Tapatalk

Heard anything back from him? Sent from my iPhone using Tapatalk

Wow! Just WOW! Sent from my iPhone using Tapatalk

Jeweler's Epoxy Sent from my iPhone using Tapatalk

Or you can just wait for SSTEEL to swoop in and save the day!!! [emoji106] Sent from my iPhone using Tapatalk

Where did you source your ETA from? When I purchased a new one from Ofrei, it came with one. Only it was a metal spacer used between the dial and DW. You should have had one. The spacer is usually standard and is tied to the movement as it needs to maintain the proper clearance from the DW. I may have a spare, but contact Ofrei to see if they may have one. Sent from my iPhone using Tapatalk

On my way home from a rough Monday. I do love my commute, though. High speed ferry! The only way to commute to and from NYC! Sent from my iPhone using Tapatalk

Thanks for the advice bud! Sent from my iPhone using Tapatalk

Thanks bud! Yeah, I tried to get that spring bar to release and ended up getting frustrated. I might give it another shot. Why remove it? I just think it just gets in the way of laying properly on my wrist. I just added another link and pushed it all the way under the slide. Sent from my iPhone using Tapatalk

Sent from my iPhone using Tapatalk

Has anyone figured out how to remove the extension? It doesn't pull out far enough for the screw to be removed. Thanks! Sent from my iPhone using Tapatalk

Good morning world! Thoughts go out to our friends in Italy. Sent from my iPhone using Tapatalk

Are you guys saying what I think your saying??? This could open a whole new world here!!! Sent from my iPhone using Tapatalk

I've been unable to remove any of them. All I end up doing is chewing the inside up. Looks like a special tool is needed.

The ring lock does come out. It's pressed in with the crystal gasket creating a seal between the ring lock and the mid-case. The hole goes all the way through. This is the HEV closed and flush. This is the HEV venting. Since I don't expect to have mine in use, I seal it with Jewelers epoxy from the inside. There is enough of a gap between the ring lock and the mid-case that would allow HE to be released. I hope this helps. [emoji6] Sent from my iPhone using Tapatalk

It is drilled all the way through and is a functioning one way check valve. Sent from my iPhone using Tapatalk

5218-210 Sent from my iPhone using Tapatalk

Sent from my iPhone using Tapatalk

Thanks bud! Sent from my iPhone using Tapatalk