mymanmatt

Looks good to me

I have. However, there are so many makers of watch cases, you don't know if it will fit your case, even though they all look the same

3035 through late 1988, not 1999. I have several dwo with open 6 and 9, so that does not confirm anything.

I have what I think are some nice ones

Ther are many gens without the crown. Most of them made in the 90"s

Lay the hand upside down on something firm, like a piece of thin cardboard, take a small piece of wood, like a cuticle remover that Im sure your wife uses. Then gently, very gently, roll it up the hand appling soft presure over the bend. Ck it and repeat as much as needed to remove the kink

It's a mans 36mm Rolex does not make a ladies day-date. However women do wear them

No. Too much rust, and rust brings corosion

You need to pm irolexu he can tell you

I wish I had known your were looking, I have a couple of 16800 dials, In pretty nice condition

Yes they will interchange for sure. The only problem you may run into is the height of the canon pinon. Most of the time the canon pinon on the 2824 is shorter than the 2836-2, not always, but most of the time. If you have enough clearance under the crystal with the 2836-2 for the sweep second not to rub, you are good to go.

I don't know if the crystal on your tc watch has a retainer, or if it presses into the case. I have crystals with the lec and I use gen cyclops on my datejust. Im not sure if it would be too much mag on your sub if it uses a retainer, sub gaskets are taller than datejust. If it is a press in, it should work well.

I have a set of gen 1570 hands for a sub

11.00 used. But new expext to spend at least 20.00

Who would buy it based on the add alone.

I think the gens are 2mm. Lowes and home depot have metric drill bits, including the 2mm drill bit. That should do it.

Ive seen this seller before, I think he is ligit. Watch looks good to me

I have dial that is very smilar to it. It has the numbers like that one, but the center is smooth not grooved

Thats a presidents mans

Most gen like constructed case will be waterproof. By that I mean, if you have a crystal that has a bezel that presses over it, most likely it is waterproof. If you have a case where the crystal presses into it, not waterproof. Of course the case tube and crown should be installed properly, and the correct gasket for the back. But, the press in crystal, will most likely leak.

If the buckle also says 78360, and 78360 is stamped on the inside of the first link, and the end pieces are stamped 580B, 800.00

wholesale outlet on ebay has one in white

None that I know of. Can you just replace the crystal?

I think your picking your watch too much. Yours turns like it should, if a gen is any tighter, then it has been worked on and the gen is not correct

I have some dwo's to the right, towards the crown, of the position yours shows